Saw an earlier post about this, but didn't see any resolution.

Boinc BAM ID 245 (computerguy09)
Host BAM ID 3699

Trying to detach from PrimeGrid on this host. I have already set this project to "Get No New Work", since I was manually load balancing this box. Each time I got to the "Host List" link, click on the specific host, and get the check boxes.

PrimeGrid is checked.
I Uncheck box by PrimeGrid
Click "Set" button at bottom of Check Boxes
Screen refreshes by itself, and status by PrimeGrid still shows Attached
Wait awhile, and it's still attached.

I've tried this from two different desktops that I have here, both from FireFox and IE 6.

Just for grins, I tried to both attach to BURP and detach from PrimeGrid at the same time, with identical results. BURP didn't get attached, and PrimeGrid didn't get detached...

Mark

Did the system that you want to detach contact BAM! after you set PG to detach?

Not sure if the system had contacted BAM yet. However, I at least would assume that the status of the system in the Host list display should have changed. In the past, when I did this, I thought that it changed from "attached" to "detaching" until a later time, probably after the host contacted BAM, when it then showed that it wasn't attached to that project.

In my BAM settings, it is set to have the host contact BAM every 3 hours.

Mark